Battery operated master clock controller for slave clock

• Will work straight out of the box.
• Gives a 24 V pulse every minute, every 30 seconds, or every second. These voltage pulses are used to drive slave clocks used in institutions like factories, offices, and schools.
• Easy to use Windows program to change pulse interval, pulse length and pulse polarity. No driver installation required. Supported operating systems: Windows 10 / 11.
• Factory calibrated for 1 second accuracy within a month.
• Crystal fine tuning to recalibrate the device if necessary.
• Will produce either unipolar or bipolar (polarity reversing) clock pulses.
• Provides a maximum output current of 50 mA.
• Capable of driving a single slave clock.
• Very low quiescent current consumption for maximum battery lifetime. The typical battery lifetime using eight AA batteries is between 8-12 months for a one minute pulse clock, but this highly depends on your slave clock device and can be longer or shorter.
• 6-12 VDC input voltage.
• 9 volts battery snap included!
• (Battery holder not included.)
• If you have a slave clock using working voltage less than 24 volts, you can calculate the value for the required series resistor here.

Download the instructions and control software from here!